Support Page Deluxe Light and Sound Sleep Aid

How to charge

Your Deluxe rechargeable light and sound sleep aid will need charging prior to use. To do this:

Remove the power unit by opening the pocket on the back of the plush toy. Insert the charging cable into the port on the base of the unit (fig A). During the charging process, the light (1) will show red. It will turn blue when fully charged. It will then flash 3 times when the battery is running low. It will take approximately 5 hours to fully charge the battery.

How to use

Before first use, clean the product. Clean before each use. Always wash the product immediately after use. Wash in warm soapy water and rinse in clean water or use a dishwasher (top shelf only). A bottle brush is perfect for cleaning the food pouch. Do not clean with solvents or harsh chemicals. Suitable for sterilisation by steam (electric and microwave), boiling, cold water tablet or liquid sterilisation and UV.

1. Light selection button
2. CrySensor switch
3. Sound selection button
4. Volume switch

 i.Make sure your light and sound sleep aid is fully charged before first use.

       ii.Turn the power unit ON using the slider (4) (fig. B) on the front of the unit and select chosen volume: off – low – mid – high.

 iii.To activate the nightlight, press the front of the sleep aid (1) (fig C). Change the brightness of the light through low, mid, high by pressing multiple times. The light will automatically turn off after 30 minutes or until you turn it off by pressing and holding the front for 2 seconds.

iv. To activate the sounds, press the back of the sleep aid (3) (fig. D). Scroll through the different sounds and lullabies by pressing multiple times. The sound will play for 20 minutes or until you stop it by pressing and holding the back of the sleep aid for 2 seconds.

How the CrySensor works:

The CrySensor allows your light and sound sleep aid to listen out for noise and respond by playing the sound or lullaby you choose to help settle your child back to sleep.

It listens out to noises in a room and is programmed to respond to crying or sharp sounds that may disturb your little one’s sleep. If there’s a rapid movement in the room, the noise may be enough to activate it.

There are 3 CrySensor settings which you can switch between using the CrySensor switch on the back of the device (2). To activate the CrySensor you must first activate the sounds on your device by pressing the back of the sleep aid.

The 3 CrySensor settings work as follows:

1. CrySensor ON: The CrySensor remains active and listens for your baby’s cry all night. When your child stirs, it will play your choice of sound or lullaby for 20 minutes and the nightlight will switch on for 30 minutes. After 30 minutes, it will then go back to listening with the CrySensor.
2. CrySensor on a 3 HOUR AUTO SHUT OFF: The CrySensor remains active and listens for your baby’s cry for 3 hours, then automatically switches off. When your child stirs, it will play your choice of sound or lullaby for 20 minutes, minutes and the nightlight will switch on for 30 minutes. After 30 minutes, it will then go back to listening with the CrySensor. If the CrySensor doesn’t detect any sounds for 3 hours, then it will automatically switch off.
3. CrySensor OFF: You can still play sounds or lullabies and use the light, but the CrySensor is not active and listening.

Cleaning & Maintenance 

How to clean 

Before cleaning, please ensure you remove the electronic module. Once removed, the fabric part of the sleep aid can be machine washed at 30° but please do not tumble dry.