Support Page Mini Travel Sleep Aid

How to charge

Your Mini Travel sleep aid will need charging prior to use. To do this:

1. Remove the power unit by opening the pocket on the back of the plush toy. Insert the charging cable into the port on the base of the unit (fig A). During the charging process, the light (3) will show red. It will turn blue when fully charged. It will then flash 3 times when the battery is running low. It will take approximately 2.5 hours to fully charge the battery.

How to use

1. Volume switch.
2. Sound selection button. Press and hold for 2 seconds to turn off.
3. Charging light.

1. Make sure your sleep aid is fully charged before first use.
2. Turn the power unit ON using the slider (1) (fig. B) on the front of the unit and select chosen volume: off – low – mid – high.

1. To activate the sounds, press the front of the sleep aid (2) (fig. C). Scroll through the different sounds and lullabies by pressing multiple times. The sound will play for 20 minutes or until you stop it by pressing and holding the back of the sleep aid for 2 seconds.

How the CrySensor works:

The CrySensor allows your sleep aid to listen out for noise and respond by playing the sound or lullaby you choose to help settle your child back to sleep.

It listens out to noises in a room and is programmed to respond to crying or sharp sounds that may disturb your little one’s sleep. If there’s a rapid movement in the room, the noise may be enough to activate it.

To activate the CrySensor you must first activate the sounds on your device by pressing the front of the sleep aid.

The CrySensor remains active and listens for your baby’s cry for 3 hours, then automatically switches off. When your child stirs, it will play your choice of sound or lullaby for 20 minutes and it will then go back to listening with the CrySensor. If the CrySensor doesn’t detect any sounds for 3 hours, then it will automatically switch off. To activate the CrySensor again, simply activate the sounds again by pressing the front of the sleep aid.

Cleaning & Maintenance 

How to clean 

Before cleaning, please ensure you remove the electronic module. Once removed, the fabric part of the sleep aid can be machine washed at 30° but please do not tumble dry.